Show us your genuine mods

Hahaha - sounds hot in summer and cold in winter!

You'll notice I carefully avoided the long-term commitment option

 

Ahhh but you see ... it has a swimming pool inside and a pot belly heater , I have all options covered ... ok albeit the pool is full of 10 inch goldfish , but its still technically a pool

 

I can't imagine why you have a pool full of 10" goldfish in your shed ... not that a bit of eccentricity worries me.

 

They breed better in the shed

 

And in 18500 mode - only about 5mm longer:

 

Dave Gilmoured...

 

Thought this would be a good enough place to put these
Only what I've got up here on site

Tube Mods...


Box Mods...

*Pic removed as sneaky clone had sneaked in...*

Specials

 

Nice collection.

...that Omega though... makes me question the authenticity of some of the other gear...

 

All I can see is my old microstick... I think... Where's the rest mate????

 

I'll see if I can get some more shots...how would I know, what should I be looking for?
As far as I'm aware it's all genuine...although it's possible something may have sneaked in earlier in my collecting, before I knew about the clone/genuine story/saga



At home mate...and that is your old microstick
This is what I've got up here on site to play with

 

Yeah, starting to move in that direction
Recently started on the RTAs and RDAs and now Nickel builds...
Now starting to have a crack at the "snob" mods which are proving to be a bit trickier...love the quality though...
Haven't got the hang of mesh builds at all...keeps tasting "metallic"...
Like to try different combinations and most of these are all in daily rotation, like the different flavours and styles of delivery...
Most of my early Ego batts/Spinners/Clearos etc have all gone as PIFs and been used to help others get off the stinkies...

Al's going to have his work cut out when he gets to my vape stand lol

 

If the Omega has any of the following features, it's a clone:

- Polished finish (should be brushed)
- Coloured (should be SS)
- Comes with drip tip, the slanted one is common (should not)
- Rounded bevelled edge on the body, just below the fins (should be a hard chamfer parallel to chamfers on fins)
- Slotted screw for the positive pin (should be flat)
- Post holes (should have none)
- Thin posts (should be very wide)
- Pan head post screws (should be truss)
- Air holes at any position other than 2 and 8 o'clock when posts are viewed horizontally
- Omega symbol is wrong (should have a rather unique omega symbol)
- Omega symbol is not centred vertically (should be)
- Serial number is sans serif (should be serif)


...yeah, I remember all this but can't remember where I put my wallet most mornings.

 

Found a perfect partner for my Rose, finally.

 

Ideas on how to run an Mcr 18500 hybrid mode without a gap?

 

use the correct batteries or a hybrid connector with correct adjustment :unknown:

 

You adjusted for the atty and battery on the hybrid adaptor?
Everything I put on I can get to sit flush

 

Yup, hellfire 510 won't screw up any further and the hybrid is on as short as possible using an aw imr.

Just received a reply from Liam, it's because it's the older hybrid adapter. If I get the spares hybrid kit he mentioned that the v2 delrin will stop this from happening.