Touch Light Sabre V2

Well, got bored again and put together another illuminated FL touch mod, this time a purple one!

It was designed for use with my CE2XL tank mod. Like the V1, it is illuminated by a bi-colored 3mm LED. The basic body was a 3-AAA aluminum 9-LED flashlight. I gutted it and recycled the PCB to build this mod.

Modded circuit board


Top view, before I potted the whole thing with hi-temp crystal hotglue


After sealing everything in hotglue


LED with master power on


LED with touchpad activated


I used both the male and female connectors from a 510 extension, the male for the touchpad, the female for the batty connector. I used the original PCB to mount all the components, including a MOSFET, 3mm bicolor LED, and several resistors.

The results are, I think, quite nice. It is designed to run on either an 18500 or 14500 battery @3.7v. Compared with the V1, which uses an 18350 batt, this one will give me a lot more time between charges.

The result is right handsome, don't you think?


This time I went for a more muted illumination. I buried the LED under close to an inch of crystal clear hotglue and aimed it sideways. Still it gives the tank a nice glow.

Master switch on


Touchpad activated


Another nice mod, and it vapes great!


Gee, this is sure fun

 

Very Nice!!! I wish had your talents! I am still just at the tinkering stage.

 

That is an intresting version of the Serenity Prayer!

Very cool as always, I don't usually comment but I look and your shit is very cool!!!

 

A tinkerer, huh? Me too

 

Thanks Of course, my fav is my GGTB (thanks NV), but I enjoy tinkering around, very therapeutic