Review on Ammit Mtl RDA

Thanks our reviewer for this review, you can get the original review here

Place an order -- ammit mtl rda


Even this is an sample from sourcemore.com, but our reviewer have an unbasized review on it.

Ok all, today we have the geekvape ammit mtl rdafor testing and yes it's supplied with squonk pin.


It's also supplied with plenty of spares including a choice of three, yes three drip tips. Each one getting slightly larger in airflow diameter.
A nice manual, guarantee cert, multi tool, and pre made Clapton coil is also included.

Now this is a single coil affair as you'd expect for mtl and the coil is gripped via ample clamp holes in the coil posts.

I've been looking forward to reviewing this one as I'm a huge mtl squonk fan so rather than use the supplied clapton I went with my usual 1.1 ohm, 2.5mm kanthal coil. Easy enough to fit but I'd say any wire smaller than 28awg May be a juggle to get clamped firmly, (we've all been there).

The design of this rda is incredibly good. The liquid squonks up into a deep deck set under the coil, so the wick tails hang down into the well and the squonk hole is set above the deck floor so a little juice reservoir is always available if you squonk regularly.

The airflow is set high up on the mtl rda and is controlled by an airflow ring with a Cyclops hole on one side which allows you to adjust from a tiny 0.8mm hole up through graduating holes. So you can effectively open as many holes as you like up to a very open mtl draw.
On the other side of the ring you have a single air hole opening allowing you to dial in the exact single airflow hole you require.

Ok, the top cap is where this rda gets interesting. Although the outer diameter is 22mm, the actual coil chamber is under 20mm as the airflow runs down the gap between the outside cap and the inner coil chamber dome. The air then enters the deck via two holes in the deck side and then come up under the coil via two airflow holes.

The under coil airflow holes are on angled slopes so you have one at the front bottom of the coil and One at a higher angle behind the coil. (Hopefully the photos show this better).

Initially when I saw this I'd lost a bit of hope, but on use. I stand corrected, the flavour is deep and rich. Absolutely spot on. Actually a similar style of vape to the berserker mtl rdabut with better flavour and less turbulence (thanks to the two angled airflow points)

The other plus of this design is a can't get it to leak. The top cap is held firmly but not as firm as some geekvape rda's. So it won't come off by accident but you can actually remove it without resorting to the tool box, lol.

So far all I can say is I've run three different juices through it at different viscosity and they've all wicked beautifully and delivered genuinely first class flavour.

I put this on my inbox yesterday to replace my ever present strike and I've no interest in swapping back anytime soon. It's definitely the equal of the strike in flavour and it has the benefit of being leak proof.

More MTL RDA via --> mtl rda