Welcome to Vape.to ! Log in or Sign up to interact with the Vape.to community.

evercool

Discussion in 'Vape Mod Talk' started by nicole_b_moore, Apr 7, 2015.

  1. So I ordered some parts to make the evercool mod. Has anyone here made one? Are there any things to watch out for? This seems a little bit more complicated then standard vv mods.

    Thanks
     
  2. IkuhoiuhiuI

    IkuhoiuhiuI Guest

    It's only a tiny bit more involved than an EverHot mod. The only advice I have for you is to follow your circuit diagram and make sure you know EXACTLY where everything's going before you start cutting.
     
  3. RoxyQueen

    RoxyQueen Guest

    well TI being the great free sample manufacturer that they are sent me my ptr08100wvd I am looking at it now. I was wanting to know of any great places for capacitors and pots. I am looking for something other then a mini screwdriver to make adjustments to the voltage with that won't kill me on cost.... ideas??
     
  4. kernal

    kernal Guest

    check out mouser, they have tons of parts and pieces to put these things together, heard good things about digikey too. And honestly, you don't NEED to use capacitors for this. I did on my very first evercool mod, and have built about 10 of them since, without the caps, never had a problem at all.
     
  5. RossG

    RossG Guest

    could you post a diagram with no caps?
     
  6. bombnhills

    bombnhills Guest

    I was doing a little more reading about capacitors and was wondering in the evercool mod is it used to "condition" or smooth the power current or what? If they can be omitted all together I am trying to see the purpose in them for the build
     
  7. Berlin

    Berlin Guest

    Caps do a couple things especially for this mod, it smooths out the ripple slightly and it helps to maintain the current. It actually helps slightly on batteries but mainly helps prolong the life of atty's in my opinion.

    I could be wrong :p

    Devil
     

Share This Page