New flashlight adapter for testing

While playing around and testing the eGo twist circuit, I needed something to test, after each solder joint was made, just to check that I had not fried the board. I remember in my early days, I built a flashlight adapter for the Provari, but must have pulled it to pieces. Anyway it was easier ti build another. I have heaps of those LED flashlights just taking up space. Ideal for the job.

End result was that I could Just leave it connected without farfing around with an atomizes or multimeter. Usual crap photo’s, but you will get the idea. Great backup flashlight as well. Need to find the epoxy to finalize things.

 

Robray lol I was thinking about doing that a couple of weeks back, great Idea. Which atomizer did you use? I like the look of it.
Jeff

 

I have a couple or three bare atomizer connections so didn't have to rape a new one. The same trick can be done with any of the clearos, or even a vision stone tank if you have any laying around.

 

Those pics are a lot more focussed than what you normally post Robray
Paying attention I see

Either cleaned your glasses or camera lens or not anaesthetised enough ??

 

Think he's just feeling embarrased after you .comght him out last time.. Being more careful?

 

margy, you are going to find it hard to believe, but the close ups are due to bluetac!!!

I have a jewelers loupe that I bluetacked to my camera phone!!! Only way I can do close ups. Need to buy a camera!!!

 

LOL

Pic of jewellers loupe blutacked to phone please ??

And I havent seen any cameras in the $2 shops either

Can't you get something duty free ??

 

margy you are getting as bad as the missus. Let me thing about the camera phone pic. Not sure how I can do that as its the only camera I own.

Duty free as too expensive for my needs.

$2 dollars is way to expensive. Will check out the Salvos next time out.