Modding my DID from Krits co-op

Hey guys looking at modding my did to get better airflow and bigger wick hole can someone help me with dimensions that would be suitable? this is my first genny so dont have others to reference.

 

im getting massive t/h from mine no mater how i set it up

 

Stoney can help yah here, once he actually stops getting shorts

 

here is View attachment 3859 View attachment 3860 a pic of my cheapo
the wick is about the same size as the centre hole with out the rubber grommet about 4mm
my air hole i went to big its 1.5mm too airy a draw but the smallest drill bit i had im getting used to it though and it really pumps out the vapour
My did is 1.2mm air hole and its great

 

View attachment 3861 View attachment 3862 here is View attachment 3859 View attachment 3860 a pic of my cheapo
the wick is about the same size as the centre hole with out the rubber grommet about 4mm
my air hole i went to big its 1.5mm too airy a draw but the smallest drill bit i had im getting used to it though and it really pumps out the vapour
My did is 1.2mm air hole and its great

 

Will drill out my wick hole tomorrow but will leave the cap alone I like it tight

 

let me know how it goes

 

lol......................

 

and here View attachment 3863 it set up before i trimmed the wick down level with the top post View attachment 3864 you can see how fat the wick is

 

i just tried and failed, im not good with tools lol

 

start off small and increase the size of the drill bit

 

What are you guys doing with your negative poles? The wire run to the bottom of the wick from that dodgy clamp is seeing loads of air.

 

Wish i could wrap nice coils like the ones in this thread.

 

Just dry fire it just to even out the glow by poking and prodding the coil

 

I have been putting the neg end of the coil in the hole with the wick.

RC