Bottom Feeder approach - feedback wanted

The 16g canula used as the injector is glued into the attie connector so it's not removable.

 

Is your design meant to be tilted downward when feeding?

 

up down sideways ;p
shouldn't matter with that design!

 

Correct, it will work in any orientation but fills best with bottle upside down on the injector.

 

Found a can of.comto touch up paint for a long gone car........

 

that looks sweet, how high does the syringe sit above the base of the 510 connector? Im half thinking of matching one of these with a rebuildable dripping atomiser and would like to ask the rda maker whether it would work?

 

hey john have you tried a cut down ego cone on it yet as drip cup?looking pretty shit hot now.

 

The injector actually sits about 1mm below the top of the 510 thread

 

I've only tried the full cone that you can see in an earlier post. Just now I pushed the plunger until juice overflowed the cone. It was a good ml and then some I reckon.

 

@floorzone.....a 150mm length of this 38x25mm extrusion I'm using will fit 2x18650s and give a bottom feeder with ~8ml capacity.

Edit: Make that 152mm long and 10ml capacity.

 

still playing in the shed with stuff john.50x25 ally box ,perspex,lumps of wood etc.having fun when i get a chance to get in there.i spose a grip feeder would be close to 130mm high but the 38x25 x150 might be a tad out of proportion.will let you know how my experiments go.

 

Depends what capacity you want in the feeder. Each extra ml adds about 12.5mm to the height.

 

I see a nice mod inside that just screaming to get out.

 

2x2600mAh 18650s and 9.5ml juice feeder.....and variable power of course

 

Despite its ungainly appearance the above mod is actually quite nice to use. It's in no way a pocket mod but for use at the desk where I spend most of my day it's very practical.

Since I put it together on Saturday I've vaped about 6ml of juice out of it using a couple of different atties and also a couple of different cartos. Since this mod uses an 18g canula for the juice injector I'd expect almost any atty or carto to work on it. I'm curious if anyone else has tried cartos on a bottom feeder.

Using it for about 50% of the time I'd expect the batteries to last a week or more. I haven't charged these at all yet as they were 3.8 volts each when I built the mod and they now at about 3.65 each.

 

I have used a boge carto on my reo. Works OK but i went back to 306 cos the flavour is better