Origen V2 Genesis issue

Hi all,

Have been vaping for about two years and thanks to this forum have not had too many problems – until now.

Recently purchased an Origen V2 Genesis. Building it is no problem, but the bell chamber that slides over the build is just too tight. It is not the top cap that holds the drip tip and screws onto the chamber that is the problem, but the bell chamber itself that slides over the atty housing.

Was just wondering if there are any other Origen Genny users here that have had this problem, whether I have just got a dud one, or whether it will just loosen up with use.

There does seem to be a couple of O-rings in the bell chamber, but lubricating these doesn’t seem to make any difference. I am thinking of removing one to see if it will free it up enough so that I can just slip it on and off, but am concerned that if I do that it may leak. Has anyone experienced this problem before and if so, how did you resolve it?

I don’t think that I can get the O-rings out without cutting them. Don’t want to stuff my new atty be.comse it really does produce great flavour.

Thanks for any help offered.
Ken

 

Is it a clone or.comthentic?

 

It's.comthentic.

 

Hmmm intresting. Im sure it'll loosen up after using it for a while. Mine was a bit tight when I first got it but after a couple of builds it was fine.

 

The damn thing is driving me crazy - it can me 20 minutes to get the chamber off.

 

Yeah it's annoying. I feel ya pain mate! But it'll loosen up eventually.