Welcome to Vape.to ! Log in or Sign up to interact with the Vape.to community.

Working with 100% VG

Discussion in 'Vape DIY Juice / Recipes / Mixing' started by Wesplems, Jun 22, 2015.

  1. Wesplems

    Wesplems New Member

    Messages:
    3
    Likes Received:
    0
    Gday

    Any tips on using 100% VG. Its a bitch to pull in a syringe with or without a needle. Tried sitting it in some hot water, not much better.

    cheers
     
  2. knz

    knz New Member

    Messages:
    4
    Likes Received:
    0
    I usually just use a 6ml syringe without the needle or a measuring cyl. Heating it a bit does thin it slightly
     
  3. Angry Grandma 2.0

    Angry Grandma 2.0 New Member

    Messages:
    4
    Likes Received:
    0
    i remove the plunger and pour in the top. finger over hole, add PG, add flavour, fit plunger, shake before getting rid of the air.
    if i am mixing more than a tank load, then squirt into a 10 ml bottle to mix further.
     
  4. bbobbyjunoray7605

    bbobbyjunoray7605 New Member

    Messages:
    4
    Likes Received:
    0
    Same as Stoney + add 5% Vodka
     
  5. Tricia

    Tricia New Member

    Messages:
    5
    Likes Received:
    0
    I use pipettes :)
     
  6. virvoyeur

    virvoyeur New Member

    Messages:
    6
    Likes Received:
    0
    i just dont use a tip. Works fine on a 10ml syringe
     
  7. Dogs coming outta my ears

    Dogs coming outta my ears New Member

    Messages:
    3
    Likes Received:
    0
    Same as Stoney then :)
     
  8. costas

    costas New Member

    Messages:
    6
    Likes Received:
    0
    I usually just pour it straight into a 100ml bottle, that has 5ml graduations on it, then add unflavored nic & PG to make my base juice, then use that to add to 30 ml bottles & add flavor.
     
Loading...

Share This Page